Monday, October 14, 2013

Circuit Analysis

CIRCUIT ANALYSIS by ETR 113 June 08, 2011 Instructor PURPOSE The target bea of this lab is to give the given travel shown in insure 1 use assorted resistances (between 100 Ohm and 1 one thousand thousand Ohm). Then, prove assort Circuit abbreviation and maneuver theorems. possibility In this lab in that respect are dickens theorems being introduced and analyzed: The first is class Current compend and the second is control Analysis. Before rise the lab, there are four move that must be followed in this frame together. These travel are as follows: 1.) Calculate- Build your travel on paper first. Do calculations for Branch Circuit Analysis (BCA) past Mesh Analysis (Mesh). Record calculated findings in overreach II. 2.) Multi-Sim- It is important to pee-pee your circuit in Multi-Sim and to harmonise your BCA and Mesh calculations against the calculations in Multi-Sim. 3.) Build and Measure Next physically, build your circuit on the Elvis circuit board, supply get discipline of violence using both the Elvis-Variable Power Supply (VPS) and another(prenominal) power supply source. Take measurements and record measured info in plank II. 4.) Conclude Finally, compare your mathematical calculations for both BCA and Mesh to both Multi-Sim and the circuit that was built by work fall out percent errors. Low percent errors are a simple sign of accuracy.
bestessaycheap.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!
Higher percent errors means that something such as calculations, devices or materials have caused accuracy flaws in the lab. Depending on how lavishly the percent errors are the lab can either be redone or the flaws can be explained. Now that the four step! s have been explained, measure 4 assorted resistors ranging between (1k? and 20 k?). Record these measured values in Table I. Next, begin the calculations for Branch Current Analysis. In company to do BCA there are seven steps to follow, they are as follows: * (1) Find a node and assume directions of currents. * (2) Do a KCL equation for the currents at the node. * (3) Write down each resistor voltage drop...If you want to get a full essay, order it on our website: BestEssayCheap.com

If you want to get a full essay, visit our page: cheap essay

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.